Winalign battery software#

the shopID and Security key are entered wrongly.

Typical reasons why the integration might not work.

once you see the (H) in front of at least one inspection, you can be sure the data integration is working and you can go to your inspection sheet definition and add all the different hunter equipment to the inspection topic, for example, a battery tester in the image below.

After the test run, you can check on the AutoVitals site for the data arriving by going to the Inspection Results page and the vehicle in the dropdown with the Hunter data attached will be marked with an (H) in front of the inspection description (see image below).

Make also sure the rep enters the VIN so our softwareВ can attach the results to the right vehicle. If your shop has Quick Check AND WinAlign, then make sure that a test for each of the products is run. then your Hunter rep will finish the integration by running a test with one of your vehicles in the shop.The equipment ID can be found in your TVP link as a 2-5 digit number shown as shopId as shown below as well. It has been the root course of integration problems in the past, so please monitor the correct entries.

Winalign battery software#

During the visit by your Hunter rep make sure that the rep enters the data exactly as shown in the upper half of the image below in your equipmentвЂ™s software panel.They will stop by your location and check your equipment and upgrade/install what is necessary to make the integration work.Determine whether or not your equipment can be integrated.If you are not integrated, please contact your Hunter rep and ask them to.